Difference between revisions of "Quick Start Guide/Configuration"

From Ethersex_Wiki
Jump to: navigation, search
(first version)
(No difference)

Revision as of 23:57, 29 March 2012

make menuconfig inside the hardware menu

After installing the required software and cloning the repository, cd to the root directory of ethersex.

General Settings

Type

 make menuconfig

to start the text-based configuration UI of ethersex. Select the default configuration by selecting (enter).

 Load a Default Configuration  --->

Now select for example

 Pollin AVR Net-IO

Back in the main menu, enter

 General Setup --->

and select your Target MCU followed by the MCU frequency in Hz

Go back to the main menu and enter the

 Network  --->

menu. Select

 Ethernet (ENC28J60) support --->

and enter the MAC address Now adjust the IP address and Netmask for your network.

Exit this menu as well as the Network menu. Hit the < Exit > button once again and select < Yes > to save your config.

Compiling

Run

 make

to start the build process. This will only take a few seconds. If everything went well, which means you see something like this...

=======The ethersex project========
Compiled for: atmega644p at 20000000Hz
Imagesize: 36057/65536 bytes (55.02%)
  [================--------------]

Program (.text + .data) : 28098 bytes
Data (.data + .bss)     :  1698 bytes

===================================

...you are ready to flash the firmware to your board!

previous step | next step