Difference between revisions of "Quick Start Guide/Configuration"
| Line 1: | Line 1: | ||
{{i18n|Quick Start Guide/Configuration}} | {{i18n|Quick Start Guide/Configuration}} | ||
| − | [[File:E6menuconfig.png|right|thumb| | + | [[File:E6menuconfig.png|right|thumb|200px| make menuconfig inside the hardware menu]] |
After [[Quick_Start_Guide/Preparation | installing the required software and cloning the repository]], ''cd'' to the root directory of ethersex. | After [[Quick_Start_Guide/Preparation | installing the required software and cloning the repository]], ''cd'' to the root directory of ethersex. | ||
Latest revision as of 15:16, 19 July 2013
After installing the required software and cloning the repository, cd to the root directory of ethersex.
General Settings
Type
make menuconfig
to start the text-based configuration UI of ethersex. Select the default configuration by selecting (enter).
Load a Default Configuration --->
Now select for example
Pollin AVR Net-IO
Back in the main menu, enter
General Setup --->
and select your Target MCU followed by the MCU frequency in Hz
Go back to the main menu and enter the
Network --->
menu. Select
Ethernet (ENC28J60) support --->
and enter the MAC address Now adjust the IP address and Netmask for your network.
Exit this menu as well as the Network menu. Hit the < Exit > button once again and select < Yes > to save your config.
Compiling
Run
make
to start the build process. This will only take a few seconds. If everything went well, which means you see something like this...
=======The ethersex project======== Compiled for: atmega644p at 20000000Hz Imagesize: 36057/65536 bytes (55.02%) [================--------------] Program (.text + .data) : 28098 bytes Data (.data + .bss) : 1698 bytes ===================================
...you are ready to flash the firmware to your board!
